|
Under normal circumstances, the feed raymond grinder should be inside the suction mouth, and blowing out is mainly caused by the following reasons:
1, check whether the throttle closed, close the damper will cause the inlet outward blowing;
Whether there is a link, check the pipe
2 of the machine leak, the leak is sucked into the local wind, not to blow this place, be sure to check carefully;
3, dust bag must one day to beat the time, keep the air bag, the normal working condition should be bulging;
4, the feed must be uniform, otherwise it will cause blockage of mill;
5, the outlet of the valve under pressure not to lift up, must press down, the configuration must be reasonable;
6, remember every day to refueling and maintenance of raymond mill is the key, the regular maintenance can reduce a lot of trouble, can make the machine get better with.
Our company raymond mill advanced technology, is the largest manufacturer China Raymond mill, the parts are made of special material forging, so that the wear degree is greatly improved, and the material in the same fineness, wearing parts service life than other factory parents 2-3 times, and no dust pollution, greatly reduce the pollution of dust and noise on the surrounding environment.
|
|