Despite their ground-ready, durable and insulated construction, submersible water pumps still present severe hazards for homeowners and should never be found in ponds intended for swimming or human immersion. The problem is simple: electricity and water don't mix. As such, installing a power submersible water pump for water gardens, natural ponds, or pools requires great skill and experience in order to avoid electrocution.

Manufacturers design submersible pumps to be safe. For example, they encase them in cast-iron housing made to isolate the electrical and working elements of the unit. All cables are shielded and sealed by standard rubber. However, the casing and the rubber shielding does not guarantee that the submersible water pump won't have any experience of water.

Water Seals
The rubber water seals on a submersible pump contain no adhesive. Instead, they form the seal due to a crimping method that tightens components within the pump. The seal insulates the within of the pump from water, humidity, and outside air.

While this produces a higher level of insulation, occasional seal failures can occur. A little malfunction would bring the within of the pump into experience of the water garden or natural pond water. The consequence of this malfunction will be electrified water within the pond https://pumpwellco.com/submersible-motor-pump/.

The Cables
Just like the primary ingredients of the pump, manufacturers go to great lengths to properly seal the cables. For example, they'll fill gaps with epoxy to stop water from invading the unit. They also wrap the cables in a neoprene, which can be both air and watertight.

Epoxy is incredibly good at forming a waterproof seal. This seal won't fail unless it's subjected to some form of impact that could lead it to crack. If the seal cracks, water could easily get in to the cable. The exact same does work for neoprene.

Regular Outlets vs. GFCI Receptacles
The National Electric Code (NEC) and OSHA require that homes now contain GFCI receptacles in areas where water exists or potentially exists. These areas include bathrooms, kitchens, utility rooms, garages, and anywhere outside. GFCI receptacles prevent electrocution by cutting off the ability source when an unusual increase or “leakage” in power, like this caused when water comes into experience of electricity, is detected.

Unfortunately, many older homes do not have GFCI receptacles. Consequently, plugging a power water pump right into a regular outlet could make it at risk of a power surge. Additionally it may increase the chance of electric shock. Therefore, if you use a power pump, you should be sure that you plug it right into a GFCI receptacle or replace your old outlet.

Freezing Temperatures Through the Winter
During winter months, it's recommended to remove the water pump from your own water garden or natural pond. Winters in Illinois produce frigid temperatures that can plummet below zero. Consequently, the water in an all natural pond or water garden may stay frozen through the season.

Frozen water will take its toll on a submersible water pump. Just one freeze may cause the casing or the cabling to crack open, exposing the electrical parts. May very well not spot the cracks because of the multilayers of the casing. Therefore, once you turn on the pump in the springtime, maybe you are at risk of electric shock.

Abrasives and Heavy Objects
Since easiest ponds or water gardens contain rocks, plants, sand, and other objects, it is very important to make sure that they do not enter into experience of the water pump.

When placing your pump, make sure to isolate it from any heavy rocks, sharp objects, or metal objects. Also, if you use sand, position the pump such that it is filtering minimal quantity of sand possible. Since sand is abrasive, it can harm the inner elements of the pump over time.

Never swim or wade in a lake with a Submersible Water Pump
You should never swim or wade in a lake or pool with a submersible water pump. Even though these pumps were created with many safety features, it's not worth the risk. You will find special pumps created for swimming pools and ponds that do not carry this risk. If you want to enter your pond or pools with a submersible water pump to retrieve something or perform routine maintenance it is crucial that you turn off the electricity to the submersible pump and enter with caution. 

Need Assistance with Your Water Garden? Contact Us Today!
If you should be getting ready to build your water garden project, then Reflections can help. We give you a wide variety of features and options to assist you create the perfect serene water garden for the backyard.